Wood Flooring Hub

Premier Hard Wood Floor Installation Resources

How can I stop my new bamboo flooring from buckling up on me ? tonge and groove ,mastic glue down on concrete.

bamboo flooring 1 Comment »

I followed manufactures instructions , cleaned concrete floor pryer to installing. opened boxes, stacked criss cross, waited two day for flooring to adjust to room temp. trowel down with mastic glue. checked floor for leveling (o.k.) Should I have left room for expantion between the tounge and grooves ?

Did you use a block seal on the slab to prevent moisture from bleeding through? You didn’t mention that in your preliminary list of steps you took. The slab should have been sealed first before anything was done. Where you leave a 1/4 inch gap is around the outer perimeter of the room where your baseboards would be placed over that gap…not between the boards.

Installing wood laminate flooring – need to figure out pattern / dimensions to cut?

laminate wood flooring 5 Comments »

I will be using Ikea wood laminate flooring. The dimensions of the panels are 8" x 54".
My entryway is basically 46" by 40".
Do I cut the panel to 46" long (actually less to accomodate the spacers) and lay them side by side?
Or, to add stability, do I cut them to a shorter length and do brick-type pattern?
Thanks for any advice – first time doing this.

First you need to look at the laminate flooring you are going to install. Some company’s use a tongue and groove design on the ends as well as the sides of there flooring. Then others use a over lap design. you will need to be able to cut these designs to alternate from the way the flooring is installed to maintain stability.

CM042s airsoft review (CYMA AK47s full metal real wood)

real wood flooring No Comments »

PLZ READ!!!!!!

UPDATE: i have done my own costom VFC mod to this gun, the bolt now goes back at least 3 times farther than i did in this vid. im gunna try to get a vid up this weekend on how to do this exclusive mod so stay tuned to WARROCKSLASHMAN1.

PLZ note if you do the VFC mod it will take away ALL of the bolt’s restence. to add more resistance to it after you do the mod, find some clicky pen springs that are the same diamiter as the one that the bolt had on it to avoid the springs getting snaged on one another. but when you do fing the right size you can add as much resistance as you want. but be warned, the more springs you put on it will slightly effect how far back the bolt will go however. its not a big deal but i just wanted to let you know in advanced.

HERE IS THE UPDATE VID!!!!!! 😀
http://www.youtube.com/watch?v=5zpf0sJ3u0I&feature=channel_page

UPDATE: i have put new parts on this gun. it now has a CM031 (ak74) muzzle break and machinery cover on it.
i think it makes it look cooler.

ALSO! DON’T USE THE BATTERY OR CHARGER THIS GUN COMES WITH! THE CHARGER SUCKS IT ALMOST MADE THE BATTRY EXPLODE!

a good battery (for the model i have)
http://www.airsoftgi.com/product_info.php?products_id=3594

the new CM042’s airsoft gun review.

the gun is full metal real wood and does 457 FPS 😀

links

the gun (the one i have)
http://www.airsoftgi.com/product_info.php?products_id=3888

the full stock model.
http://www.airsoftgi.com/product_info.php?products_id=3887

the mags
http://www.airsoftgi.com/product_info.php?products_id=2671

the red dot
http://www.airsoftgi.com/product_info.php?products_id=2905

if you have any questions about this gun please ask. i will be more than happy to help.

AND FOR ALL YOU LITTLE CALL OF DUTY FANBOYS THIS IS NOT AN AK74 U!!!

THIS IS ALSO MY 1ST LIVE VIDEO AND AIRSOFT REVIEW!!!

Duration : 0:3:45

Read the rest of this entry »

Technorati Tags: , , , , , , , , , , , , , , , , , , , , , , , , , ,

Install Quick-Step Laminate Flooring 1

bamboo flooring No Comments »

Quick-step laminate flooring is very cool laminate flooring brand. Here are first part of how to install it guide. The process is very easy

Duration : 0:6:13

Read the rest of this entry »

Technorati Tags: , , , , , , , , ,

How To Mop a Wood Floor

solid wood flooring No Comments »

Watch this video for a demonstration of “How To Mop a Wood Floor”. To complete the task, you will need:

A broom, or a vacuum cleaner with a floor attachment
A bucket of water
Some wood cleaner or dishwashing liquid

Get started with the first step: Make sure your floor is sealed. If it’s not, it’s probably waxed and shouldn’t be mopped. Check by rubbing a finger across it. If you don’t leave a smudge, the floor is probably sealed.

For the complete guide, go to http://www.howcast.com/videos/280-How-To-Mop-a-Wood-Floor

Also check out Howcast for other do it yourself videos from Darlene212 and more videos in the Floors category.

How can you contribute? Create your own DIY guide at http://www.howcast.com/videos/new or apply to the Howcast Emerging Filmmakers Program at http://www.howcast.com/filmmakers/apply

Duration : 0:1:54

Read the rest of this entry »

Technorati Tags: , , , , , , , , , , , , , , , , ,

How to fix your Wood Floors

engineered wood flooring No Comments »

patrickdaiglefloorshttp://gdata.youtube.com/feeds/api/users/patrickdaiglefloorsPeoplepatrick daigle flooring, fix wood floors, fix a scratch, repair wood floors, wood floors, Hardwood floor repairsHow to fix your Wood Floors

Duration : 0:3:13

Read the rest of this entry »

Technorati Tags: , , , , ,

Flooring Tutorial – How to Use a Belt Sander to Sand a Hardwood Floor

hard wood floor refinishing No Comments »

Wojtek shows us some simple tips for operating a hardwood floor belt sander. In this video, you are shown how to gently drop the drum of the Lagler Hummel Floor Sander, to sand forwards and backwards, and to overlap slightly into the next pass. Visit http://www.onlinefloorstore.com for more tutorial videos.

Duration : 0:1:35

Read the rest of this entry »

Technorati Tags: , , , , , ,

iRobot Roomba Rattle on engineered flooring

engineered floor No Comments »

Roomba louder on engineered flooring compared to solid oak flooring.

Duration : 0:1:34

Read the rest of this entry »

Technorati Tags: , , , ,

Housekeeping Tips : How to Make Hardwood Floors Shiny

hardwood floor refinishing No Comments »

Making hardwood floors shiny requires cleaning them with water and vinegar, which helps to disinfect the floor, but wood conditioning treatments can also be used periodically. Keep hardwood floors looking new with a demonstration from a professional home cleaner in this free video on housekeeping.

Expert: Rachel Yatuzis
Contact: www.greenkleeninc.com
Bio: Rachel Yatuzis is a professional house cleaner in Nashville, Tenn., specializing in using everyday household items for cleaning purposes.
Filmmaker: Tim Brown

Duration : 0:3:9

Read the rest of this entry »

Technorati Tags: , , , , , , , ,

Laying Wood Floor

hardwood floor installation No Comments »

Roughly one minute of video recorded for each row of laminate wood flooring sped up

Duration : 0:1:45

Read the rest of this entry »

Technorati Tags: , , ,